|
|
| Articles - Accessories and Enhancements |
Keoni986 05-16-2010 12:17 PM
Here's how to do it and what is needed:
Two Torx screwdrivers, and a ruler (either inch or metric).
- Remove the driver's side sun visor. Unclip the the small cover to the right of the visor and remove one Torx screw.
- Remove the two Torx screws on the left.
- Pull gently on the side trim piece from the top and stop about a 45 degree angle. The bottom of the trim piece is held in by a clip.
- Push the clip towards the left a little bit while pulling up gently on the trim piece....
17 Comments
Mark Hubley 03-25-2010 08:19 PM
A few years ago I purchased an auxiliary input for my CDR-220 from SW Stereo. I think it cost $20 or $30. Here is my version of a how-to installation. Unfortunately, I did not think to take pictures during the installation; sorry.
The aux input plugs into the back of the head unit and terminates in a pair of RCA jacks. I added a 6' RCA to 1/8" cable from Radio Shack and snaked it under my center console, past the shifter, and behind my "non-smoker tray." I also purchased a female-female...
|
|
|
All times are GMT -4. The time now is 01:29 AM.
